DIY Guide: How to Install Oil Jock in 10 Minutes

Car maintenance often sounds complicated and expensive, bringing to mind skinned knuckles and hefty repair bills. But what if you could solve your messy oil leak problem in less time than it takes to make coffee? With this friendly guide, you can confidently tackle oil leak prevention yourself.

We’ll walk you through how to install Oil Jock, a stress-free solution for any driver. You don’t need a fancy workshop or advanced mechanical skills. Just a few simple tools and ten minutes are all it takes to master this piece of DIY car maintenance.

Can You Really Install Oil Jock Yourself?

Let's bust a myth: you do not need to be a "car person" to install Oil Jock. The system is designed for everyone. Since it straps externally to your vehicle, you won't be messing with complex engine parts. If you can use a wrench, you can do this.

To get started, you’ll need your Oil Jock kit, a wrench or socket set (usually 10mm-15mm), and a mat to lie on.

How to Install Oil Jock: A Step-by-Step Guide

Ready to protect your driveway and the environment? Here’s how to install your oil leak catcher in just a few simple steps.

Step 1: Safety First

Park on a flat, level surface and engage the parking brake. Always wait for the engine and exhaust to cool down completely (at least 30 minutes after driving) before you begin.

Step 2: Find Your Anchor Points

Slide under your vehicle and locate the oil pan, which is the lowest part of the engine. Oil Jock uses existing bolts on your car's frame, crossmember, or the oil pan itself, so no drilling is required. Identify two sturdy bolt locations on either side of the leak. Avoid moving parts like steering components or hot surfaces like the exhaust pipe.

Step 3: Position the Oil Jock

Hold the Oil Jock unit under the engine, directly beneath the leak. Ensure the absorbent hydrophobic pad faces up towards the engine and the hard shell faces down towards the road. Leave about an inch of space between the Oil Jock and any engine parts to prevent rubbing.

Step 4: Secure It in Place

This is the final step in your DIY car maintenance task.

1. Attach the front mount to a cross member using the two provided self-tapping screws for a solid anchor.
2. Slip the main tray into the hinge of the front mount and swing it up so it’s horizontal.
3. Loosen one of your chosen rear anchor bolts just enough to slip in the Oil Jock’s mounting strap, then retighten it securely.
4. Repeat on the other side for the second rear anchor point.

Step 5: The "Wiggle Test"

Give the installed Oil Jock a firm wiggle. It should feel secure, not loose. If it moves too much, simply tighten the straps. The high-quality, fiberglass-infused nylon is built for durability, so make it snug. Trim or tuck away any excess strap material.

Flawless Installation Tips

• Check Clearance: Ensure the Oil Jock doesn’t hang lower than your vehicle’s lowest point to avoid scraping on speed bumps.
• Pad Check: Part of good vehicle maintenance is regular checkups. Inspect the pad during your oil changes (every 3,000-5,000 miles) and swap it out if it’s full.

Congratulations! You’ve just installed a powerful barrier against oil leaks, protecting your driveway and the environment without a costly trip to the mechanic.

Find replacement pads or get an Oil Jock for another vehicle at oiljock.store and keep your garage completely leak-free.